| Step | NEXGEN Side-Eject |
Conventional End-Eject |
1 |
Feed Material | Insert front end of wire ties |
2 |
Fill until "bale made" signal | Feed Material |
3 |
Insert wire and tie off | Fill until "bale made" signal |
4 |
Depress "home" button | Insert rear end of wire ties |
5 |
Open door | Walk behind to tie bale |
6 |
Eject bale w/eject switch | Feed front wire ties for next bale |
7 |
Lift bale with forklift | Open door |
8 |
Retract server island | Engage "flag pole" gauge |
9 |
Close door and repeat | Feed next bale to push out bale |
10 |
Retract "flag pole" | |
11 |
6 |
Extract wedged bale from chamber |
12 |
Less |
Lift bale with forklift, etc. |
13 |
Steps! |
Clean up spillage |
14 |
Adjust wire on loose bale | |
15 |
Close door and repeat |